This article first appeared in Sacramento Valley Orchard Source
Missing the Target: Why you Should Irrigate Potted Trees Directly onto Potting Media
or
Why Emitters Should be Placed on the Root Ball at Planting
Dani Lightle, UCCE Orchards Advisor, Glenn Butte & Tehama Counties
N.B. potted trees are standard commercial container grown citrus and avocado trees
Generally, when I am working with growers on a problem related to potted-tree establishment, the cause is lack of water movement into the potted media, creating tree stress. This results from the difference in soil particle size at the boundary between the orchard soil and the tree's potting soil. When you plant a potted tree in your orchard, it has a substrate – some mix of peat and vermiculite – that is very different than your soil type. The change in texture and pore size inhibits water movement from the surrounding soil into the potting media. As a result, Irrigation water applied outside the potted soil media isn't getting to the roots.
The sequence of photos in Figure 1 demonstrates this phenomenon. I set up a mock orchard condition with soil (Tehama series silty loam) next to a potted tree (potting soil) in a ½ inch wide frame. I then slowly added water to match the soil infiltration rate, similar to a drip emitter, approximately 4 inches away from the potting soil in the ‘orchard' soil.
You will see that the water does not move into the potting soil (Figure 1C & D). Two forces – gravitational pull and capillary action – move water downward and laterally in the soil. Since the potting soil is not below the orchard soil, gravity does not move water into the potting soil. Capillary action is not strong enough to move water into the potting soil because the difference in pore size is too great. So, irrigation water goes where it can easily flow – downwards and laterally into dry, native soil but not into the potting soil. More water does not solve the problem, it will just move past your newly planted trees and wet more native soil.
For about the first month of growth, irrigation emitters should be located at the base of the potted tree to ensure the potting medium receives water. Frequently check to ensure that the potting soil stays wet – not the soil somewhere else in the tree row or mound – before, after, and between irrigation sets. The best way to do this is with a small trowel and your hands. Water will need to be applied at the base of the tree until the tree roots grow beyond the potting soil and into your orchard's native soil. The time required for this to happen will vary depending on factors such as temperature, but it should take roughly a month.
Figure 1. This sequence of photos shows the movement of water applied to Tehama series silty-loam soil. Water was applied at the blue arrow, approximately 4 inches from the potting soil. Total elapsed time was 51 minutes. Water moved downwards and laterally but did not cross the boundary into the potting soil.
Attached Images:
